This is the Futaba 7C 2.4GHz Helicopter Radio System
with the R617FS FASST 7-Channel Receiver and no servos.
This is the helicopter version which will default to heli settings
when powered up and does not have a ratcheted throttle stick.

Modeler can change from the default mode (mode 2 in USA) by holding the
Mode and End keys and then turning transmitter On to access the STK feature,
changing mode and turning transmitter Off and then On again.
It is recommended to send transmitter to the Futaba Service Center
to change switch operation.

FEATURES: Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts
very quickly virtually eliminating signal conficts and
interruptions unlike other 2.4GHz systems that only stay on one
or two frequencies
Dual antenna diversity enables FASST system to automatically and
seamlessly select the best reception between the two antennas
built into the receiver ensuring that the aircraft stays under
constant control of transmitter regardless of altitude
Newly designed Dial-N-Key jog dial with joy stick button allows
cursor movement in four directions for very user friendly
navigating through menus and programming

INCLUDES: Futaba 7C 2.4GHz Transmitter
R617FS FASST 7-Ch Receiver (FUTL7627)
FBC-19B(4) 120V Battery Charger (FUTM1830)
NT8S600B 600mAh 9.6V NiCd Transmitter Battery (FUTM1457)
Switch Harness w/Charge Cord (FUTM4370)
Black Transmitter Neck Strap (FUTM5690)
Servo mounting hardware and instruction manual

SPECS:      7C 2.4GHz Transmitter
Current Drain: 170mA

R617FS FASST Receiver
Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: 0.34oz  (9.8g) with case, 0.25oz  (7g) without case